Honda NC700 2012, Руководство по обслуживанию

Страница: 400 / 773

12-45
dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
5. Inner Mainshaft Sensor Ground Line Open
Circuit Inspection
Disconnect the PCM 33P (Gray) connector.
Check for continuity between the wire harness side
inner mainshaft sensor 3P (Black) connector [1] and
PCM 33P (Gray) connector [2] terminals.
Is there continuity?
YES – Replace the PCM with a known good one,
and recheck.
NO – Open circuit in the Green/yellow wire
6. Inner Mainshaft Sensor Output Line Open
Circuit Inspection
Turn the ignition switch OFF.
Disconnect the PCM 33P (Black) connector.
Check for continuity between the wire harness side
inner mainshaft sensor 3P (Black) connector [1] and
PCM 33P (Black) connector [2] terminals.
Is there continuity?
YES – GO TO STEP 7.
NO – Open circuit in the Gray/yellow wire
7. Inner Mainshaft Sensor Output Line Short
Circuit Inspection
Check for continuity between the wire harness side
inner mainshaft sensor 3P (Black) connector [1]
terminal and ground
Is there continuity?
YES – Short circuit in the Gray/yellow wire
NO – GO TO STEP 8.
8. Inner Mainshaft Sensor Inspection
Turn the ignition switch OFF.
Replace the inner mainshaft sensor with a known
good one (page 12-115).
Erase the DTCs (page 12-13).
Test-ride the motorcycle and stop the engine.
Check the DTC with the HDS pocket tester.
Is DTC 53-1 indicated?
YES – Replace the PCM with a known good one,
and recheck.
NO – Faulty original inner mainshaft sensor
Connection: Green/yellow – B22
TOOL:
Test probe
07ZAJ-RDJA110
B22 [1]
G/Y
[2]
Connection: Gray/yellow – A20
TOOL:
Test probe
07ZAJ-RDJA110
A20
Gr/Y
[2]
[1]
Connection: Gray/yellow – Ground
[1]
Gr/Y