−
−
〈
〉
〈
〉
45
Do not bend the remote control
cable as sharp as its route diameter
is 300 mm (11.8 in.) or less, or it
affects the service life of the cable
and the remote control lever
operation.
Remote Control Box Location
Remote Control Cable Length
Propeller Selection
(R1 type)
INSTALLATION (R type)
REMOTE
CONTROL BOX
REMOTE
CONTROL
CABLE
CONTROL
LEVER
Install the remote control box in the
position where is easy to operate the
control lever and switches.
Be sure that there are no obstacles on
the route of the control cable.
The control box position of the R2
type and the R3 type should be
determined in the same manner.
Measure the distance from the
control box to the outboard motor
along the cable routing.
Recommended cable length is
300
450 mm (11.8
17.7 in) longer
than the measured distance.
Set the cable along the pre-
determined route and be sure that it is
long enough to the route.
Connect the cable to the engine and
be sure it is not kinked, bent sharp,
pulled taut, or interfered while
steering.
Consult with your authorized Honda
outboard motor dealer for proper
propeller selection.
Use of the outboard motor outside
the full throttle speed range will
adversely affect the engine and cause
serious problem. Use of the correct
propeller assures powerful
acceleration, top speed, excellency in
terms of economy and cruising
comfort, and it assures longer engine
life as well.
Engine speed varies according to the
propeller size and the boat condition.
Select the adequate propeller so that
the engine speed at full throttle is
5,000 min
(rpm) to 6,000 min
(rpm) when the boat is loaded.
05/10/26 09:51:15 3CZW0612_045
