Honda HSM1380i, Руководство пользователя

Страница: 59 / 130

57
CAUTION:
[HSM1390i]
Do not turn the mode selector switch to another position while the
snow thrower is moving. The electronic control unit will interpret this
as a failure; the snow thrower will stop moving and the auger will stop
turning.
When the snow thrower and auger stop moving/turning, move the
main shift lever to the N (neutral) position, release the drive clutch
lever.
Check each part to verify it is in its proper position before resuming
operation.
3a. Clearing in AUTO mode (HSM1390i)
Setting the mode selector switch at the AUTO position can
simplify clearing the snow. AUTO mode keeps the auger from
rising, adjusts the engine speed automatically, etc.
1) Operate the chuter control
switch to adjust the snow
discharge direction and angle
(see page 30).
2) Operate the auger housing
control switch to adjust the
auger to be parallel to the road
surface (see pages 53 through
55).
[ETDR type]
• You can return the auger to
the initial position by pushing
the reset switch.
• If you return the auger to the
initial position by pushing the
reset switch, the auger can hit
against the road surface or
can be raised from the road,
resulting in some snow left
on the ground, depending on
the road condition and the
position of the snow thrower.
Adjust the auger position as
needed.
CHUTER CONTROL SWITCH
AUGER HOUSING CONTROL SWITCH
RESET SWITCH
36V156410.book 57 ページ ２０１８年１０月１０日 水曜日 午前１１時３０分