Honda HSM1380i, Руководство пользователя

Страница: 53 / 130

51
NOTE:
• Adjust the skid equally on both sides.
• Be sure to tighten the skid and scraper bolts securely after making
adjustment.
CAUTION:
Do not use the snow thrower on rough or uneven surfaces with the
auger ground clearance set for hard snow or surfaces.
This may cause serious damage to the snow blowing mechanism.

Adjust the skid and scraper in the following cases
• When the auger interferes with the road surface while it is turning:
• When clearing the snow from the graveled road:
Raise the auger approximately 12 mm from the ground and secure
the skid in this position.
Secure the scraper by raising it 7 mm from the ground.
Do not clear the snow thoroughly from the ground. Leave some on
the ground to prevent gravel and other foreign material being
caught in the auger.
• To break down the hardened snow that dropped from the roof:
• When the snow is too hard to dig in, making the snow thrower
rise on the snow:
Raise the skid and scraper to the uppermost position of the
adjustment range with the auger in contact with the ground, and
secure the skid and scraper in position.
CAUTION:
Note that the road surface can be damaged and stones can be thrown
out of the auger if it comes in contact with the ground. Return the skid
and scraper to the original position when operating the snow thrower
under normal conditions.
AUGER
Approx. 12 mm min. 7 mm min.
SCRAPER
SKID
SKID
SCRAPER AUGER
Raise to the uppermost
position.
36V156410.book 51 ページ ２０１８年１０月１０日 水曜日 午前１１時３０分