Honda HRR216VKA K10, Руководство пользователя

Страница: 24 / 183

2-13
HRR216VKA SERVICE INFORMATION
K8 thru K11
MOWER WILL NOT SELF-PROPEL WHEN THE SMART DRIVE IS ENGAGED
1. Inspect the drive belt, transmission input shaft, Smart
Drive cable, and pulley condition.
2. Inspect the transmission control arm, Smart Drive cable,
and return spring. Replace as necessary.
3. Verify the transmission pivots and the control arm moves
when rotating the Smart Drive control.
• If the control arm does not move, go to “SMART DRIVE
DISASSEMBLY AND INSPECTION” on page 11-23 .
• If the control arm moves, go to “CABLE
ADJUSTMENT” on page 3-10 .
.
(K8 ~ K11) TRANSMISSION PROPELS THE MOWER, BUT SLIPS OR SLOWS DOWN
UNDER LOAD
1. Adjust the Smart Drive cable ( P. 3-10 ).
2. Inspect the belt and both pulleys for damage. Confirm that
the transmission pulley is tight and not slipping on the
input shaft.
3. Position the mower on a smooth concrete surface.
4. Start the engine and firmly engage the Smart Drive control
while holding the lawn mower from moving forward. The
rear wheels should spin (slip) on the concrete surface.
If the wheels intermittently stop and/or a clicking sound
can be heard, inspect the pinion gears and ratchets
(see “(K8 ~ K11) ONLY ONE WHEEL PROPELS OR ONE
WHEEL INTERMITTENTLY STOPS ROTATING UNDER
LOAD (CLICKING SOUND CAN BE HEARD)”
on
page 2-16 ).
If both wheels stop but no ratcheting or clicking sound can be heard, the clutch may be worn and transmission
replacement is necessary.
Inspect the drive
belt, pulley, and
input shaft.
Inspect the transmission control arm, Smart
Drive cable, and return spring for damage.
Hold the mower from moving
forward and engage the Smart
Drive control on a smooth
concrete surface.
SERVICE BULLETIN #98 =>
SERVICE BULLETIN #104 =>