Honda HHT36AXB, Руководство пользователя

Страница: 9 / 86

English |
7
Troubleshooting
Problem Possible Cause Corrective Action
Blade guard can not be
mounted over cutting
blade
Incorrectassembly Removecuttingbladeandmountbladeguardfirst
Machinefailstooperate Batterydischarged Rechargebattery
Batterytoohot/cold Allow to cool/warm
Machine runs
intermittently
Motor protector has activated Allowmotor/electronicstocoolfor5minutesand
cut in stages
Internalwiringofmachine
damaged
Contact authorised service dealer
On/Offswitchdefective Contact authorised service dealer
Externalcablingdamaged Contact authorised service dealer
Machine does not cut Cutting blade damaged Replacetheblade(alwayswearprotectivegloves).
Ensurebladeisnotupside-down(8Tandsaw
blades) .
Increased vibration Cutting blade damaged Replacetheblade(alwayswearprotectivegloves)
Cutting line broken Replaceline(seefigure7ofillustrations)
Debris build up on cutting head Clean slip plate groove
Blade nut loose Tighten nut bolt to 20 Nm ensuring the blade, nut
shield and dome washer are all present and central
(alwayswearprotectivegloves)(seefigure5of
illustrations)
Machine leaves ragged
finishand/orlabours
Grass too high/dense Grass too high: Cut in stages
Grasstoodense:Reducerateofcuttingeverytime
Cutting blade blunt Flip/replace blade
Cutting blade obstructed Check underneath the machine and clear out as
necessary(alwayswearprotectivegloves)
Bladefittedinincorrectdirection
ofrotation
Re-fitbladecorrectly(only8Tandsawblades)
Debris build up on cutting head Clean slip plate groove
Motor starts then stops
immediately
Lowbatterycapacity Ensurebatteryisfullychargedbeforeuse
Batterynotfullycharged Checkbatterydisplay–chargebatteryifnecessary
Batterytoohot/cold Allowbatterytocooldown/warmup–checkbattery
display
Grass too high/dense Grass too high: Cut in stages
Grasstoodense:Reducerateofcuttingeverytime
Nut cannot be removed to
release cutting blade
Damagedthreadonnut/shaft Lubricateshafttoaidremoval
Lockingpinnotlocatedcorrectly Reinsertlockingpinandapplylightpressurewhilst
rotatingshaft(seefigure5ofillustrations)
Cuttingbladefailsto
rotate
Cutting blade obstructed Check underneath the machine and clear out as
necessary(alwayswearprotectivegloves)
Blade nut loose Tighten nut bolt to 20 Nm ensuring the blade, nut
shield and dome washer are all present and central
(alwayswearprotectivegloves)(seefigure5of
illustrations)
d.c.