Honda FL5540K0, Руководство оператора

Страница: 24 / 56

FRONT LOADER ASSEMBLY
BUCKET
10.
Using the bottom holes on the bucket,
attach both sides of bucket to loader
frame. Use two each
3/4
x
3
inch pins and
clip pins.
Attach both cylinders to top holes on
bucket. Use two each x
3
inch pins
and clip pins.
The loader is now ready for hydraulic fluid.
314 x PINS
HYDRAULIC FLUID SERVICING
You will need
6
1/2 quarts of a good grade
hydraulic fluid or ATF automatic transmission
fluid.
11.
Remove filler plug and oil
check screw
on
back of left mast. Fill with
4
hydraulic fluid.
.
Start tractor engine and set speed at
1/2
throttle. Engage tractor front PTO and
operate loader lift and bucket cylinders at
least five or six times to purge the system
of air. Lower the loader to the ground.
Retract bucket cylinders by pulling back
on handle
"B.
Add 2 1 more quarts of hydraulic fluid or
until oil runs out of check hole. Replace oil
fill plug and oil check screw.
NOTE:
When lowering loader, DO NOT push
loader handle
"A"
all the way forward into
FLOAT.
VALVE HANDLES
I'
22