Date of Issue: February, 2005
© American Honda Motor Co., Inc.
9-11
FG110
d. ROCKER ARM/VALVE LIFTER REMOVAL/INSTALLATION
REMOVAL
1. Remove the adjusting screw lock nuts [1] and remove the
adjusting screws [2] from the rocker arms [3].
Remove the cam pulley
.
2. Tighten the holder bolt [1] of the special tool fully as shown.
Set the special tool on the cylinder head over the rocker arm and
valve lifter that you are going to take apart, and tighten the bolt (5
mm) [3] to the cylinder head cover installation boss [4] by hand.
Do not tighten the bolt (5 mm) using a wrench.
3. Tighten the push rod [1] of the special tool by hand until the tip of
the push rod comes to the center of the valve lifter shaft [2]. Move
the special tool left and right and check that it can be moved
slightly.
4. Using a 14 mm wrench [1], tighten the push rod [2] until the shaft
of the valve lifter goes out from the rocker arm [3].
Loosen the push rod and remove the bolt (5 mm) [4], and then
remove the special tool.
The valve lifters and rocker arms cannot be reused after they are
pressed apart. Always replace with new parts.
TOOL:
Rocker arm replacement tool [2] 070PF-Z0HA100
[3]
[2]
[1]
[1]
[2]
[4]
[3]
It should be able to move slightly in
this direction.
(Or the cylinder head cover
installation boss will be damaged)
[1]
[2]
[1]
[2]
[3]
[4]
Revised: March, 2015
© American Honda Motor Co., Inc.
Содержание FG110
Страница 3: ...Date of Issue February 2005 American Honda Motor Co Inc...
Страница 7: ...Date of Issue February 2005 1 4 American Honda Motor Co Inc FG110 NOTES...
Страница 35: ...Date of Issue February 2005 4 6 American Honda Motor Co Inc FG110 NOTES...
Страница 79: ...Date of Issue February 2005 11 4 American Honda Motor Co Inc FG110...
