Honda CRF450X 2009, Руководство пользователя и соревновательное пособие

Страница: 53 / 184

Servicing Your Honda
47
HONDA O/M CRF450X (Eu) 3RMEY620 00X3R-MEY-6200
Coolant
Your CRF’s liquid cooling system dissipates
engine heat through the coolant jacket that
surrounds the cylinder and cylinder head.
Maintaining the coolant will allow the cooling
system to work properly and prevent freezing,
overheating, and corrosion.
Coolant Recommendation
Use high quality ethylene glycol antifreeze
containing corrosion protection inhibitors
specifically recommended for use in aluminum
engines. Check the antifreeze container label.
Use only distilled water as a part of the coolant
solution. Water that is high in mineral content or
salt may be harmful to the aluminum engine.
Using coolant with silicate inhibitors may cause
premature wear of water seals or blockage of
radiator passages. Using tap water may cause
engine damage.
The factory provides a 50/50 solution of
antifreeze and water in this motorcycle. This
coolant solution is recommended for most
operating temperatures and provides good
corrosion protection.
Decreasing the concentration of antifreeze to less
than 40% will not provide proper corrosion
protection.
NOTICE
Increasing the concentration of antifreeze is not
recommended because it decreases cooling
system performance. Higher concentrations of
antifreeze (up to 60%) should only be used to
provide additional protection against freezing.
Check the cooling system frequently during
freezing weather.
Checking & Adding Coolant
Refer to Safety Precautions on page 25.
1. With the engine at normal operating
temperature, check the coolant level in the
reserve tank. It should be between the UPPER
(1) and LOWER (2) level marks.
If the reserve tank (3) is empty, or if coolant
loss is excessive, check for leaks and see your
Honda dealer for repair.
(1) UPPER level mark (3) reserve tank
(2) LOWER level mark
2. Remove the reserve tank cap (4).
Always add coolant to the reserve tank.
Do not attempt to add coolant by removing
the radiator cap.
(4) reserve tank cap
3. Add coolant to the reserve tank as require to
bring the coolant level to the UPPER level
mark.
4. Install the reserve tank cap.
(2)
(1)
(3)
(4)