Honda CBR125R, Руководство пользователя

Страница: 126 / 430

FUEL SYSTEM (PGM-FI)
5-34
5. MAP Sensor Output Line Open Circuit
Inspection 2
Check the continuity between the ECM test har-
ness and sensor unit 5P connector of the wire
side.
Is there continuity?
YES – Faulty sensor unit (MAP sensor)
NO – Open circuit in Light green/yellow wire
MIL 7 BLINKS (ECT SENSOR)
• Before starting the inspection, check for loose or
poor contact on the ECT sensor 3P connector and
recheck the MIL blinking.
1. ECT Sensor Input Voltage Inspection
Turn the ignition switch OFF.
Disconnect the ECT sensor 3P connector.
Turn the ignition switch ON (and engine stop
switch " ": CM and U type).
Measure the voltage at the ECT sensor connec-
tor of the wire side and ground.
Is the voltage within 4.75 – 5.25 V?
YES – GO TO STEP 3.
NO – GO TO STEP 2.
2. ECT Sensor Short Circuit Inspection
Turn the ignition switch OFF.
Check for continuity between the ECT sensor
connector of the wire side and ground.
Is there continuity?
YES – Short circuit in Yellow/blue wire
NO – GO TO STEP 3.
Connection: 27 – Light green/yellow
Lg/Y
SENSOR UNIT 5P CONNECTOR
(Wire side/female terminal)
(27)
Connection: Yellow/blue (+) – Ground (–)
Standard:
4.75 – 5.25 V
ECT SENSOR 3P CONNECTOR
(Wire side/female terminal)
Y/Bu
Connection: Yellow/blue – Ground
Y/Bu
ECT SENSOR 3P CONNECTOR
(Wire side/female terminal)