© 2004 American Honda Motor Co., Inc - All Rights Reserved.
AII 25716-25817 (0404)
9 of 9
25. Check that all wire harnesses are routed properly
and all connectors are plugged in.
26. Reconnect the negative cable to the battery.
27. Enter the customer’s radio anti-theft code, and
reset the radio station presets.
28. Set the clock.
29. Check the operation of the player according to the
its Owner’s Manual.
30. Put the player Owner’s Manual in the glove box.
31. Reinstall all removed parts.
NOTE: Whenever the battery is disconnected, the
driver’s window AUTO function is disabled.
32. Start the engine. Push down fully on the driver’s
window switch until the window is fully open.
33. Pull up fully on the driver’s window switch to close
the window completely, then hold the switch for
2 seconds or more.
34. Use the window switch to check the window
AUTO function.
22. Using scissors, cut one EPT sealer into three
pieces.
23. Using isopropyl alcohol, clean the player panel
where the EPT sealers will attach. Attach the EPT
sealer to the player panel, and cut off the excess.
24. Insert the player panel clips into latches, and
attach the player panel to the instrument panel
with the two self-tapping screws you removed in
step 5. Remove the masking tape.
21. Attach the two grommet screws to the player
panel in the square holes shown.
2306131T
GROMMET
SCREW
PLAYER
PANEL
2306141T
SELF-TAPPING
SCREW (reused)
LATCH
PLAYER
PANEL
CLIP
2612010T
EPT SEALER
(Cut off the
marked area.)
PLAYER
PANEL
8 mm
8 mm
EPT SEALER
