Honda 1990 Prelude, Онлайн руководство пользователя

Страница: 35 / 143

Cruise Control
Cruise Control
The Cruise Control system allows you to set and automatically
maintain any speed above 30 mph (45 km/h) without keeping your
foot on the accelerator. As its name implies, it is meant for cruising
on straight, uncongested highways or freeways. It is not
recommended to be used in traffic, on winding roads or in bad
weather conditions where the driver should have total control.
To Set the Cruise Control:
Push the CRUISE CONTROL
master switch on the dash; the
indicator light will come on.
Accelerate to the desired
speed, then, push and release
the SET switch on the
steering wheel. The Cruise
C o n t r o l l i g h t o n t h e
instrument panel will come
on.
The speed you were going when you released the SET switch is the
speed the Cruise Control will hold. You can then "fine tune" the set
speed by briefly holding and releasing the SET switch to decrease it
a few mph or pushing the RESUME switch to slightly increase it.
To Cancel the Cruise Control:
Push the CRUISE CONTROL
master switch and the indicator
light will go off (this also erases
the memory of the set speed),
if you must temporarily disengage the system (but you wish to
retain the memory of the set speed): tap the brake pedal, or the
clutch pedal (manual transmission) or move the automatic trans-
mission shift lever to N (Neutral). If you are still going above 30 mph
(45 km/h), you can return to the set speed by simply pushing the
RESUME switch. If the car has decelerated below approximately
30 mph (45 km/h),you can return to the set speed by using the ac-
celerator conventionally until your speed is above 30 mph (45 km/h)
and then pushing the RESUME switch.
MASTER SWITCH
RESUME SWITCH
Push
SET SWITCH
(cont'd)
Main Menu
▼ ▲