© 2015 American Honda Motor Co., Inc - All Rights Reserved.
2 of 3
0SR95-HL4-211A
USE AND CARE INFORMATION
• Completely read and understand the instructions
before installing this accessory.
• Do not tow the vehicle on an open trailer with
this accessory installed, as the accessory is not
designed for use at highway speeds.
• To clean, sponge with mild soap and cold water,
rinse with a hose and allow it to drip-dry.
• Do not machine wash or dry.
• Use mild detergent to remove stubborn stains.
• The rear window can be rolled up and stowed using
the webbing strap and snaps.
• When not in use, the window roll up straps can be
fastened to themselves using the snaps.
• Do not force the zipper on the rear window. In case
of a jam, unzip and remove any obstructions. If
problems persist, the zipper must be cleaned.
• The zipper should be cleaned using a toothbrush
with soap and water and rinsed as needed to keep it
free of dust and dirt. Once the zipper is cleaned, the
teeth should be lubricated using beeswax.
INSTALLATION
1. Hook the upper J-channels to the side edges of the
of the center cab frame cross bar braces as shown.
2. Drape the mid-panel over the center cab frame
cross bar and then affix the hook-and-loop fasteners
tightly around the cross bar as shown. Pull the rear
side-net release buckles through the slots in the
mid-curtain.
3. Attach the upper hook-and-loop fasteners around
the upper frame tubes and then back to the mating
hook-and-loop fastener at the upper outside edge of
the mid-panel as shown.
J-CHANNEL
CROSS BAR BRACE
BAR B
HOOK-AND-LOOP FASTENER
SLOT
OT
HOOK-AND-LOOP FASTENER
D-LOOP
