© 2005 American Honda Motor Co., Inc. - All Rights Reserved.
AII 28606 (0502)
1 of 4
INSTALLATION
INSTRUCTIONS
Accessory
Application
Publications No.
Issue Date
FEB 2005
08P35-SJC-1000-91
2006 RIDGELINE
FULL NOSE MASK
P/N 08P35-SJC-100
NOTE: The nose mask cannot be installed if the
vehicle is equipped with fender flares, front lower
trim or an air deflector.
PARTS LIST
Mask
(bumper section)
Mask
(hood section)
2 Snap-screws
2 Washers
2 Fenderwell nuts
TOOLS REQUIRED
Stubby #2 Phillips screwdriver
Clip remover
Scissors
Storage bag
INSTALLATION
NOTE:
•
Make sure the vehicle and the nose mask are
clean and completely dry before installation. If
moisture under the mask is allowed to dry, it may
cloud the paint. If the mask gets wet, remove it
and allow it to air-dry completely.
•
Make sure any repainted surfaces are cured.
•
Make sure the hood and nose of the vehicle have
been waxed with a high-quality paste wax.
•
Make sure you install the nose mask securely. If
the nose mask starts to flap or comes loose while
driving, safely pull off the highway, stop the
vehicle, and secure or remove the mask.
Displaying the License Plate
If your state law requires the display of both license
plates, cut out the piece of the bumper section that
covers the front license plate:
•
Face the inside of the mask toward you.
•
Carefully cut out the license plate section with
scissors at the top seam, and remove the overcast
stitching.
AII 28606
BUMPER MASK
OVERCAST STITCHING
(Remove for license plate.)
Put this information in the glove box with the vehicle owner's manual.
