© 2010 American Honda Motor Co., Inc - All Rights Reserved.
4 of 8
08L56-MFY-1002-91
CLIP
REAR FENDER
HARNESS
Pull out from
the rear fender.
6.5 mm (17/64 in)
DRILL BIT
MARKED POINT
MARKED POINT
REAR FENDER
REAR FENDER
WOOD BLOCK
WOOD BLOCK
SUB-FRAME
MOUNTING HOLES
9. Insert a 6.5 mm (17/64 in) drill bit through the
mounting hole in the sub-frame as shown. Make a
mark on the inside of the rear fender by twisting the
drill bit with your fingers.
12. Drill the rear fender at the marked points as shown.
Remove any burrs from the edge of the hole.
•
<Right side>
<Left side>
10. Repeat the above procedure on the remaining right
and left side mounting holes.
11. Remove the rear fender as shown.
<View from the underside of the rear fender.>
ELECTRIC DRILL
(30 mm HOLE SAW)
ELECTRIC DRILL
(30 mm HOLE SAW)
