2 of 2
AII 31066 (0510)
©
2005 American Honda Motor Co., Inc. - All Rights Reserved.
4.
Slide the bracket onto the receiver unit. If the
vehicle is equipped with an XM radio, refer to the
XM radio installation instructions for the
installation procedure to install the receiver unit.
5.
Position the bracket on the steering hanger beam
and install the flange bolt supplied.
7.
Check that all wire harnesses and cables are
routed properly and all connectors are plugged in.
8.
Reinstall the driver’s dashboard lower cover.
9.
Reconnect the negative cable to the battery.
10. Enter the customer’s radio anti-theft code, if
applicable, and reset the radio station presets.
11. Reset the clock.
12. Check operation of the keyless entry according to
the owner’s manual supplied.
NOTE: Whenever the battery is disconnected, the
driver’s window AUTO function is disabled.
13. Start the engine. Push down on the driver’s
window switch until the window is fully open.
14. Pull up on the driver’s window switch to close
the window completely, then hold the switch for
2 seconds or more.
15. Lower and raise the driver’s window to check the
operation of the driver’s window AUTO function.
2709030K
STEERING
HANGER BEAM
BRACKET
RECEIVER
UNIT
FLANGE
BOLT
2709040K
BLUE TAPE
VEHICLE 5-PIN
CONNECTOR
RECEIVER
UNIT
6.
Locate the 5-pin connector blue-taped to the
vehicle harness, and remove the blue tape to free
the 5-pin connector. Plug the 5-pin connector into
the receiver unit.
