12 of 14
AII 27936 (0408)
©
2004 American Honda Motor Co., Inc - All Rights Reserved.
BUS CABLE
WIRE TIE
CUSHION TAPE
VEHICLE
HARNESS
FLOOR
CROSS
MEMBER
Loop the bus cable,
and secure it to the
vehicle harness with
four wire ties and one
cushion tape.
53. Route the bus cable so that its connector is
about 50 mm farther than the vehicle 20-pin
connector. Secure the bus cable to the vehicle
harness with two wires in the areas shown.
54. Secure the bus cable to the vehicle harness with
two wire ties in the areas shown.
55. Near the parking brake lever, secure the bus cable
to the vehicle harness with three wire ties in the
areas shown.
56. Loop the excess bus cable at the floor cross
member, and secure it to the vehicle harness with
four wire ties and one cushion tape. Clean the area
where the cushion tape will attach with isopropyl
alcohol.
VEHICLE 20-PIN
CONNECTOR
About 50 mm
WIRE TIE
BUS CABLE
CONNECTOR
VEHICLE
HARNESS
BUS CABLE
WIRE TIE
BUS
CABLE
VEHICLE
HARNESS
WIRE TIE