14 of 14
AII 25886 (0308)
© 2003 American Honda Motor Co., Inc - All Rights Reserved.
2N27090M
WIRE
TIE
WITH
CLIP
WIRE
TIE
WITH
CLIP
WIRE
TIE
WIRE
TIE
ANTENNA
UNIT CABLE
XM RADIO
HARNESS
FM
MODULATOR
ANTENNA
CABLE
WIRE TIES
WITH CLIPS
ANTENNA UNIT
CABLE
(Bundle the
excess cable.)
SUBANTENNA
CABLE
DISPLAY
MODULE
CABLE
2N27100M
6 x 12 mm
WASHER-
BOLTS (4)
UNIT BRACKET
DRIVER’S SEAT
SEAT RAIL
FM
MODULATOR
UNIT
53. Get the five wire ties with clips and two wire ties.
Secure all of the cablse to the unit bracket in the
order shown:
XM radio harness, subantenna cables, and the
display module cable.
XM radio harness, subantenna cables, and the
display module cable.
Antenna unit cable, XM radio harness,
subantenna cable, and the display module
cable.
Subantenna cable and FM display unit cable.
FM modulator unit cable and the antenna unit
cable.
55. Slide the driver's seat forward, and install the unit
bracket to the driver’s seat rails using four
6 x 12 mm washer-bolts. Tighten the bolts
securely.
56. Check that all of the wire harnesses are routed
properly and all of the connectors are plugged in.
57. Reconnect the negative cable to the battery.
58. Set one of the radio station presets to FM 88.7
and check the operation of the XM radio. If
necessary, use the XM radio Owner’s Manual
supplied.
59. Reinstall the driver’s seat. Take care not to pinch
the display module cable. Torque the seat bolts to
47 N·m (35 lbf·ft).
60. Reinstall all of the removed parts.
61. Enter the customer’s radio anti-theft code, and
reset the radio station presets.
62. Set the clock.
NOTE: Whenever the battery is disconnected,
the driver’s window AUTO up function is disabled.
63. Start the engine. Push down on the driver’s
window switch until the window is fully open.
64. Pull up on the driver’s window switch and close
the window completely, then hold the switch up
for at least 2 seconds or more.
65. Test the window AUTO up function.
