Page 4 of 7
ENGINE #12
FEBRUARY 2013
Position the end of the bolt against the auto-
choke plunger and slowly push it until the flange
nut seats and slowly release.
Do this slowly several times and make sure the
choke control operates smoothly and springs
back when released. If any binding exists, the
auto choke assembly must be replaced.
10. Inspect the air guide and insulator gaskets.
Replace any gasket that appears damaged.
11. Install the auto-choke control assembly onto the
6 x 85 mm flange bolts.
12. Install the insulator gasket in the direction
shown. Be sure the gasket opening aligns with
the intake port.
13. Pick up the assembled air cleaner case,
carburetor, and auto choke assembly as a unit.
Install it to the cylinder barrel by aligning the
two 6 x 85 mm flange bolts with their mounting
holes. Loosely install the bolts.
