HomeTech EF494, Инструкция по установке и эксплуатации пользователя

Страница: 6 / 12

Warning: Always disconnect from the power supply before cleaning heater.

For general cleaning use a soft clean duster-never use abrasive cleaners. The glass viewing
screen should be cleaned carefully with a soft cloth. DO NOT use proprietary glass cleaners.
Warning: Always disconnect from the power supply before removing bulb.
Warning: The bulbs reach high temperatures during operation. Allow the bulbs to
cool down after switching off the appliance before changing lamps.
Note: Two people will be required for this process.
1. It is recommended that the fire is carefully removed from the wall and laid on its back in order to
replace the lamp.
2. Gently slide the front panel towards the top of the fire and remove. Store the panel safely out of
the way whilst the bulb is replaced so that it does not get damaged.
3. At the bottom of fireplace, there is a lamp cover fixed by six Philip's head screws
Remove the six screws and lift off the lamp cover (see Fig. 5 of diagram)
4. For access to the bottom bulbs, carefully slide the flexible rotisserie to one side ensuring that the
rubber grommet is not lost (see Fig. 6 of diagram)
5. Remove the defective bulb by unscrewing it.
6. Replace with a 40W E12 SES Clear Candle bulb, rotating it. Take care not to over-tighten the
bulb.
7. Refit the rotisserie making sure that the rubber grommet is carefully pushed into the slotted hole
on the axial bracket.
8. Lift the fire back onto the wall and replace the front panel by lifting onto the lugs either side of the
fireplace.
Supply
: 110V-120V~ 60Hz
Rated power : 1500W
Lighting : 40W E12 SES Clear Candle bulb
CLEANING
REPLACING THE LAMP
TECHNICAL SPECIFICATIONS