Assembly Instructions 9/9
Hardware List
STEP 16
Drill a 3/16” hole 1/2” deep 1” from top in
middle of side panel that is against a wall.
Place unit at desired location.
Drill a 3/8” hole in wall in-line with
3/16” hole drilled in side panel.
Move unit.
Insert Anchor into the wall hole
and attach Bracket with Wall Screw.
Attach Bracket at drilled hole in
side panel with Wood Screw.
Move unit back into place.
Slide Tipover Restraint through
Bracket on wall and Bracket on side panel.
(See Figure 6)
Put tie end of Tipover Restraint into lock
end of Tipover Restraint and pull until tight.
Anchor
1 pc. (+1 extra)
Bracket
2 pcs. (+1 extra)
Tipover Restraint
1 pc. (+1 extra)
M3.5x40
Wall Screw
1 pc. (+1 extra)
M3.5x16
Wood Screw
1 pc. (+1 extra)
Figure 6
Wood Screw
Wall Screw
Bracket
on wall
Anchor in wall
3/8” wall hole
3/16” hole in
side panel
Tie end
Lock end
Bracket
on side panel
Tipover
Restraint
Per regulatory requirements, a Tip-over Restraint is included. Follow Step 16 to install it.
Drill 3/16” hole in side panel
Drill 3/8” hole in wall
