Homestyles F06M3PW15XZE, Руководство пользователя

Страница: 5 / 14

HomeStyles, VerS08
F06M3PW15XZE
5
1. Always disconnect the cord from the electrical outlet when cleaning your fan.
2. Light accumulated dust may be removed by using a soft cloth to wipe away the dust at the back grille of the
fan.
3. Wipe the exterior surfaces of the fan occasionally with a damp cloth (not dripping wet) and dry thoroughly
with a soft dry cloth before operating the fan.
4. Do not use harsh cleaners or materials to clean this unit, doing so will cause damages to it. Cleaning is
required every 3-4 months.
CAUTION: DO NOT ALLOW WATER TO RUN INTO THE INTERIOR OF THE FAN AS THIS COULD
CREATE A FIRE OR ELECTRIC SHOCK HAZARD. THE FAN MOTOR IS FACTORY LUBRICATED FOR
LIFE AND WILL REQUIRE NO FURTHER LUBRICATION. NO OTHER USER MAINTENANCE IS REQUIRED
OR RECOMMENDED. IF SERVICE IS REQUIRED, SEND YOUR FAN TO THE NEAREST AUTHORIZED
SERVICE DEPOT.
1. Follow cleaning instructions 1-4 above.
2. Retain the original packaging to store your fan.
3. Never store while still plugged in.
4. Never wrap cord tightly around the fan or put any stress on the cord where it enters the fan as it could
cause the cord to fray or break.
If your fan fails to operate, please follow these procedures prior to contacting customer service:
PROBLEM PROBABLE CAUSE SOLUTION
Fan is not turning on. A. Fan is not plugged into a
120V AC, 60Hz polarized
outlet/receptacle.
B. Breaker/fuse has been
tripped.
A. Ensure unit is in the OFF position. Plug in unit
and attempt to turn on again.
B. Please check your electrical box to confirm
the breaker has not been blown. Ensure unit
is in OFF position. Plug in unit and attempt to
turn on again.
Attempt to plug unit in another receptacle in
the house.
The fan is not tilting
back.
It has already reached its tilting
limit.
This fan has a tilting angle of 90 degrees. There
will be resistance once it has reached its limit. Do
not attempt to tilt the unit futher than it is intended
to go. For more information on tilting, refer to
page 4.
Fan is on but air
coming out of it is not
strong enough.
There is dust built up at the back
of the fan.
Turn fan OFF and unplug. Using a soft, dry cloth,
wipe the back of the grille to remove any dust
build-up. Plug in unit and turn fan back ON to
resume normal operation.
If the problem still persists, refer to the warranty. For further instructions, call 1-800-268-7622 or visit
www.super-electric.com with the model number of this fan ready for the service center.
PLEASE DO NOT ATTEMPT TO OPEN OR REPAIR THE FAN YOURSELF. DOING SO COULD VOID THE
WARRANTY AND CAUSE DAMAGE OR PERSONAL INJURY.
CLEANING & MAINTENANCE
STORAGE
TROUBLESHOOTING