Z-Wave ZRW103 Series 200 Instructions, Release 2.2
P/D 012108
HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
0763-01
4
at all (set to 0), to flicker the entire time it is transmitting (set to 1), or to flicker for only 1 second when it begins
transmitting (set to 2). By default, the ZRW103 is set to flicker for only 1 second.
• Parameter No: 19
• Length: 1 Byte
• Valid Values = 0, 1 or 2 (default 2)
Each Configuration Parameter can be set to its default setting by setting the default bit in the Configuration Set
command. See your controller’s instructions on how to do this (and if it supports it).
All Configuration commands will be reset to their default state when the ZRW103 is excluded from the Z-Wave network
by using the controller to reset the node (on the ZTH100 select “SETUP” and scroll to “RESET UNIT”).
SUC Support
There must be a
Static Update Controller
in your Z-Wave system for this feature to work. The Static Controller
can act as a gateway in the system, since other nodes always know its position (not moved after addition to the
network. The “always listening” advantage of the Static Controller is that other nodes can transmit information frames
to it whenever needed.
You can assign an “SUC Route” to the ZRW103. Refer to your controller’s instructions on how to do this (if it supports
it). Assigning an SUC Route to the ZRW103 allows it to request an update of the Z-Wave devices that are between
it and the Z-Wave device to which it was trying to transmit. The ZRW103 will only request an update when a
transmission fails.
SPECIFICATIONS
Power:
120 VAC, 60 Hz
Signal (Frequency):
908.42 MHz
Maximum Load:
Resistive : 20 amps (2400 watts) maximum, 120 VAC
Motor: 1 H.P. maximum, 120 VAC
Incandescent: 960W maximum, 120 VAC
Range:
Up to 100 feet line of sight between the Wireless Controller and /or the closest
HomePro Receiver Module
INTEROPERABILITY WITH Z-WAVE™ DEVICES
A Z-Wave™ network can integrate devices of various classes, and these devices can be made by different
manufacturers, just as the ZRW103 can be incorporated into existing Z-Wave™ networks.
The top or bottom of the ZRW103 switch paddle can be used to carry out inclusion (inclusion to the network by adding
to a group), association (operate simultaneously with other nodes), exclusion (remove from a group) or reset (remove
from the network). Controllers can be replicated in order to provide operation from other locations.
WARRANTY
For warranty and general product information visit our web site at www.act-solutions.com
ABOUT ZRW103’S CERTIFICATION
The ZRW103 is certified to comply with applicable FCC and IC
rules and regulations governing RF and EMI emissions.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) This device must accept any interfer-
ence received, including interference that may cause undesired
operation.
FCC NOTICE
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
