HomeMatic HmIP-BSM-I, Инструкция по установке и эксплуатации

Страница: 38 / 111

38
Restoring factory settings
7.4 Error codes and flashing sequences
Flashing code Meaning Solution
Short orange flash-
ing
Radio transmission/
attempting to trans-
mit/data transmis-
sion
Wait until the transmission is
completed.
1x long green flash Transmission con-
firmed
You can continue operation.
1x long red flash Transmission failed
or duty cycle limit is
reached
Please try again (see „7.1
Command not confirmed“
on page 36 or see „7.2
Duty cycle“ on page 37).
Short orange flash-
ing (every 10 s)
Pairing mode active Enter the last four numbers
of the device serial num-
ber to confirm (see see „6.4
Pairing“ on page 35).
6x long red flashes Device defective Please see your app for er-
ror message or contact your
retailer.
1x orange and 1x
green flash
Test display You can continue once the
test display has stopped.
8 Restoring factory settings
The device’s factory settings can be restored. If you do this, you will
lose all your settings.
To restore the factory settings of the device, please proceed as follows:
• Remove the rocker (if necessary).
• Press and hold down the system button (A) for 4 s with a pointed
object (e.g. a pen) until the LED will start flashing orange quickly
(see figure 12) .
• Release the system button.
• Press and hold down the system button again for 4 seconds, until
the LED lights up green
(see figure 13) .
• Release the system button again to conclude the procedure.