Homematic IP 154666, Инструкция по установке и эксплуатации

Страница: 43 / 153

43
Start-up
You can manually start the pairing mode for another 3 minutes by
pressing the system button
(C)
shortly (see figure 6) .
• Your device will automatically appear in the Homematic IP app.
• To confirm, enter the last four digits of the device number (SGTIN)
in your app or scan the QR code. Therefore, see the sticker
supplied or attached to the device.
• Wait until the connection is completed.
• If pairing was successful, the LED (C) lights up green. The device
is now ready for use.
• If the LED lights up red, please try again.
• Select the desired solution for your device.
• Allocate the device to a room and give the device a name.
5.2 Mounting
Please read this entire section before starting to mount the device.
You can operate the wall thermostat with
• the supplied double-sided adhesive strips or
• the supplied screws
to fix it to a wall.
You can also mount the wall thermostat on a flush-mounting box.
5.2.1 Adhesive strip mounting
For mounting the wall thermostat using the
adhesive strips
, please
proceed as follows:
• Choose a site for installation.
Make sure that the mounting surface is smooth, solid, non-disturbed,
free of dust, grease and solvents and not too cold to ensure long-
time adherence.
• Insert the electronic unit (A) into the mounting plate (see figure