Page 6 of 12
3 Components – Change Images
4 Preparation
•
When ready to use the cooler, make sure that the power switch is set to OFF and
the unit is disconnected from the power point.
•
Ensure the rubber drain plug is fully inserted
into the hole (located in the rear of the unit
at the bottom).
•
Remove the top cover and pour clean cold water into the water tray.
•
The water will drain down through the small hole into the water tank inside.
1 Control Panel
5
Water Level Window
2 Left-Right Louver
6
Remote Control
3 Up-Down Louver
7
Rear Mesh Filter
4 Castor Wheels
8
Drain Plug
Note
: 2 x AAA batteries for the Remote Control are not included
1
2
3
4
6
7
5
8
Drain Plug
Pour Water in
Here Only
Water will drain
down through this
hole into the
water tank
