Homelite HPHD40, Руководство оператора

Страница: 13 / 20

starts to fire
2.
3.
PRIME – press the primer bulb 10 times slowly.
4.
SET
the the choke lever to the “
START
” position.
5.
Lock the throttle by depressing the trigger lock first, then squeezing the throttle trigger,
6.
PULL the starter rope with a quick firm and consistent motion until the engine fires or
(Max “6” pulls).
7.
If the engine fires (pops) but does not continue to run, move the choke lever to the “ RUN ”
position and continue to start the engine
8.
If the engine starts and runs, pull the throttle trigger to release it from the throttle lock position
and move choke lever to the “ RUN ” position.
Allow the engine to warm up for 5-20 seconds .
NOTE: If the engine does not start, repeat from step 2.
1. Remove auger bit (if attached).
PULL the starter rope with a quick firm and consistent m otio n u n til the e n gi n e starts
(Max “4” pulls).
and pressing in the throttle lock button.
-
Press the engine switch to the “ STOP” position and hold until engine stops.
Grip the post hole digger firmly with both handes and keep all parts of the body away from
the auger bit and muffler.
post hole digger without
overreaching.
(Max “2” pulls).
NOTE:
If the engine does not start, return to step 2 under “
TO START A COLD ENGINE
”.