3
10
10
2
2
2
11
3
3
J
L
7
Diagram #1
REQUIRED HARDWARE IN THIS STEP
1. Attach seat frame (L) to back frame (J) using 7 spring washers (2), 7 flat washers (3), 3
short bolts (11) and 4 long bolts (10) as shown. Do not tighten at this point.
Note: Use the 3 short bolts (11) in the 3 holes near the center of the back of the seat frame
(L) and the 4 long bolts (10) in the back corners of the seat frame (L).
NO. DESCRIPTION
SKETCH
QTY
3
2
10
FLAT WASHER
SPRING WASHER
LONG BOLT
7
7
4
11
SHORT BOLT
3
CHAIR ASSEMBLY INSTRUCTIONS
12 2 3
M
N
O
P
L
J
4. Attach the left and right front legs (M&N) to seat frame (L) using
4 spring washers (2), 4 flat washers (3), and 4 hex nuts (12) as shown.
Do not tighten at this point.
5. Insert the front crossbar (O) into the oval holes of left and right front legs (M&N) as shown.
The small holes on the edge of the crossbar need to face towards the bottom of the leg.
6. Insert side crossbars (P) into the round holes of left and right front legs (M&N) and back
frame (J). The small holes on the bottom of the crossbars must face the bottom of the chair.
Diagram #3
REQUIRED HARDWARE IN THIS STEP
NO. DESCRIPTION
SKETCH
QTY
3
2
12
FLAT WASHER
SPRING WASHER
HEX NUT
4
4
4
14
OPEN END WRENCH
1
13
L
K
J
Diagram #2
2. Place seat board (K) upside down on a non-abrasive table surface. The rear (tapered end)
of the seat board (K) should be near the table edge.
Hint: Protect the non-abrasive table surface and seat board (K) by laying a towel in-between
the chair seat and table.
3. Place the assembled chair frame on the seat board (K) as shown. Attach with 6 wood
screws (13).
REQUIRED HARDWARE IN THIS STEP
NO. DESCRIPTION
SKETCH
QTY
13
WOOD SCREW
6
13
13
13
13
