• If the pump gurgles, spews, or “burps”:
Check the water level to make sure the pump has enough water to function.
• Obtaining a desired water level:
Check the water level daily the first week to measure the rate of evaporation; refill
with water as needed.
• If water is splashing outside the fountain:
Stones that are hit by water and also touch the edge of the base will cause water
to splash outside of the base and contribute to the splash factor. Expect some
splash to occur as you get the stones organized.
If splash continues, rearrange the stones by moving them away from the edge of
the base and/or adjust the Flow Control Lever to a lower setting. To access the
Flow Control Lever, located on the back side of the pump, follow the instructions
to clean the pump located on the previous page. The Flow Control Lever controls
the pump speed. The speed is indicated by a plus (+) and minus (-) sign. To
increase the speed, move the switch in the direction of the plus sign. At its highest
speed level, the switch will cease to move any further. To decrease the pump
speed, move the switch toward the minus sign. Similarly, at its lowest speed, the
switch will cease to move any further (Figure 9).
NOTE:
It is recommended the pump be set at its highest speed and later
adjusted to a lower setting if desired. Be sure to unplug the pump before adjusting
the speed setting.
8
9
• To keep water clean
:
Periodically change water and clean the product according to the water
condition. Keeping the water clean prevents the water from becoming sticky and
forming micro-organisms. We recommend distilled water to prevent mineral build up.
• To clean off hard water deposits on the base or rocks:
Soak the container and rocks in a mixture of vinegar and water to clean and
remove any mineral build-up.
• Keeping the water at an optimum level:
Add water periodically to keep water level at an optimum level to avoid shortening
the life of the pump.
NOTE:
Never let the pump run dry, as this will shorten the life of the pump.
• Fountain Storage
Unplug the fountain from the electrical outlet, empty the water, and store rocks and
fountain in a dry, cool place.
Troubleshooting
• If the pump fails to operate, check the following:
Check the circuit breaker, or try a different outlet to make sure the pump is getting
electrical power. NOTE: Always disconnect from electrical outlet before handling the
pump.
Check the pump discharge and tubing for kinks and obstructions. Algae build up
can be flushed out with a garden hose.
Remove the pump inlet to access the impeller area. Turn the rotor to ensure it is
not broken or jammed.
NOTE:
Monthly maintenance will add to your pump’s life.
ATTENTION:
In order to get
best results,
please operate
pump completely
submerged.
Keep the water
level above the
minimum water
level ALL THE
TIME.
Figure 9
Minimum Water Level
Flow Control Lever
(+) faster water output
(-) slower water output
