3
G
B
PRODUCT FEATURES:
INSTRUCTIONS FOR USE:
IMPORTANT - Preparing the appliance for use
The Shiatsu Massager comes with a screw located on the back of the unit to
protect the massage mechanism during shipment, which must be removed
before the first use to allow the shiatsu feature to function. Use the provided
Allen key. Then, properly dispose of the screw.
Warning - Failure to remove screw may cause permanent damage to
the massager.
Error:
all remote control LEDS flash for a few seconds.
Cause:
massager overloaded.
Solution:
ensure the allen key bolt/screw has been removed from back of the
massage cushion (using the allen key included). Should the condition continue
after this please contact your HoMedics service centre.
NOTE:
complete steps 1 to 3 before switching the appliance on at the mains.
1. Attach the Massage seat to almost any chair using the integrated strap
located at the back of the seat. Ensure it is held firmly in place by adjusting
the strap as necessary.
2.
Connect the power supply into a
220-240V
AC mains outlet.
3. Once seated, use the control to operate the appliance. Press the
q
button
&
select the desired massage zone to start the massage.
4.
Press the
q
button to stop the massage.
NOTE:
• There is a 1
5
minute auto shut-off on this appliance for your safety. This feature
should not be considered as a substitute for ‘OFF’. Always remember to switch
the appliance off when not in use.
• The moving Shiatsu mechanism always
“p
arks” or finishes in its lowest
position. It will continue to this position after the power has been turned off. If
the electrical supply is interrupted, when power is restored, the mechanism
will
“p
ark” or move to its lowest position.
MAINTENANCE:
Cleaning
Unplug the appliance and allow to cool before cleaning. Clean only with a soft,
slightly damp sponge.
• Never allow water or any other liquids to come into contact with the appliance.
• Do not immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, glass / furniture polish, paint thinner etc
to clean.
Storage
Place the appliance in its box or in a safe, dry, cool place. Avoid contact with
sharp edges or pointed objects which might cut or puncture the fabric surface.
To avoid breakage, DO NOT wrap the power cord around the appliance.
DO NOT hang the unit by the cord.
Power Button
q
To start a massage, press the ‘POWER’
button and the LED will illuminate to
confirm your selection. To turn off, simply
press the button again. The LED will blink
while the massage mechanism returns to its
starting point before switching off.
Moving
Shiatsu massage
mechanism
(Shiatsu) Massager Zone Button:
Full Back
Pressing this button once gives a full massage
up and down the back.
Upper Back
Pressing this button twice gives a massage
focusing on the mid to upper back.
Lower Back
Pressing this button three times gives a
massage focusing on the mid to lower back.
Heat Button
For soothing heat when massage is on, simply
press the heat button. To deselect, press the
button again. For your safety, heat cannot be
turned on if massage is not selected.
Mains Adaptor
IB-SBM180HEU-1116-02.qxp_Layout 1 15/11/2016 16:58 Page 3
