HoMedics ParaSpa SELECT, Инструкция по эксплуатации

Страница: 5 / 5

Red LED Indicator
Indicates the heating
element is on
Variable
Heat Control
Tub
Green LED Indicator
Indicates unit is plugged
in and power is on
P A R A F F I N B A T H
Para
Spa Select
™
Lid
8
How to Change Timer Batteries
The ParaSpa Select timer comes equipped with two LR44 watch
batteries. These batteries will maintain the time clock and “Use
Time” settings when the unit is unplugged.
NOTE : When unplugged the LED will not illuminate however, the
unit has a memory feature which will retain the correct time settings
until the unit is plugged in again.
NOTE : Never change batteries unless paraffin wax is solid and at
room temperature, or the tub is completely empty (see Maintenance
section).
1. Remove screw from battery compartment door using a small
phillips screwdriver. (See Fig. 10)
NOTE : Never remove any screws from the base other than that of
the battery compartment.
2. Remove old batteries and replace with fresh LR44 watch batteries.
Make sure to match charge symbols (+/-) on the battery to those
inside the battery compartment, as illustrated in (Fig. 11).
3. Replace battery compartment door. Insert the side with the 2
prongs first. Finish reattaching door by replacing screw.
NOTE : Make sure to securely tighten screw when replacing door.
Maintenance
Periodically, the used portion of paraffin wax should be replaced and
the unit should be cleaned.
1. Unplug unit and remove grate. Allow paraffin wax to solidify
overnight.
2. Push on one end of paraffin wax block. This will tip it up. Lift the
block out of the unit and dispose of it. DO NOT USE SHARP
OBJECTS TO REMOVE THE PARAFFIN WAX BLOCK, THIS MAY
SCRATCH OR DAMAGE THE TUB. If the paraffin wax does not
remove easily, plug unit in and allow to heat for 10–15 minutes
then remove the paraffin wax block and unplug the unit.
3. Wipe the inside of the unit with a disposable towel to remove
residual dirt and residual paraffin.
4. With a damp, soapy cloth, wipe clean. DO NOT POUR WATER
INTO THE UNIT, OR IMMERSE THE UNIT IN WATER.
5. Store in a cool, dry place. When you are ready to re-use the
ParaSpa Select paraffin bath for the next heat treatment, repeat
steps 2-6, “How to set up the ParaSpa Select unit”. Then, follow
steps 1-3, “How to use the paraffin treatment without timer
function”.
Figure 10
Figure 11
Minute
Set
Hour
Set
Auto-On
Timer Set
Timer
On/Off Selector
3 -1lb. Bags of Paraffin Wax
1 Grate
and 30 Liners
are also included
PAR120-B 10/1/01 10:47 AM Page 9