4
5
INSTRUCTIONS FOR USE
1. Always make sure the unit is set to the “OFF” position before inserting the plug into a 240 volt electrical
outlet.
2. Massage: To turn the unit on, simply slide the ON/OFF switch, located along the top of the unit’s handle up
one notch. To adjust the intensity of the massage, slide the selector switch down for lower intensity, up for
higher intensity.
3. Massage with Heat: Locate the two red (heat) attachments. Make sure the massager is turned off and
unplugged from the power outlet. Attach to the massage head by turning clockwise to secure. Plug in the
massager and turn on the power. Slide the ON/OFF button two notches up for massage with heat. Allow a few
minutes for heat to fully activate.
NOTE: TO ELIMINATE THE RISK OF BEING BURNED, NEVER USE THE HEAT FUNCTION
WITHOUT THE ATTACHMENTS. DO NOT USE THE HEAT CONTINUOUSLY FOR MORE THAN
15 MINUTES. DO NOT USE THE HEAT IF YOU HAVE SENSITIVE SKIN, POOR CIRCULATION,
DISCOLOURED AREAS, SWELLING, BURNED, INFLAMED OR WHERE SKIN ERUPTIONS OR
SORES ARE PRESENT. HEAT SHOULD BE PLEASANT AND COMFORTABLE. SHOULD PAIN OR
DISCOMFORT RESULT, DISCONTINUE USE AND CONSULT YOUR PHYSICIAN.
4. Apply massager head lightly to the area you wish to massage.
5. Move the unit slowly, holding on the targeted area. Massage the area for a short period of time and move to
another area. Never massage the same spot longer than 3 minutes. CAUTION - as stated in the “IMPORTANT
SAFETY INSTRUCTIONS” section of this manual, never use this appliance on or near eyes or other highly
sensitive areas.
6. Operation of longer than 15 minutes is not recommended and may cause overheating.
7. When massage is completed, turn unit off, unplug the power supply, allow to cool and store properly in a dry
place.
MAINTENANCE
TO CHANGE ATTACHMENTS
Your massager comes equipped with two custom massage head attachments. Each set is a different density:
GREY
- Soft
RED
- Heat and/or Hard
To change to a different set, simply twist off (counter-clockwise) the set that is on the unit and twist on (clockwise)
the desired set.
Ensure the massager is turned off and unplugged from the power outlet prior to changing the attachments.
TO CLEAN:
Be sure to unplug the unit and allow it to cool before cleaning. Use a soft, slightly damp cloth to wipe. Never allow
water or any liquids to come into contact with the handle.
TO STORE:
Unplug the appliance from the outlet and allow it to cool before storing in its box or a clean, dry place. Coil the
cord and secure it with the supplied fastener. Do not hang the unit by the power cord.
iHOM4897_PA-5H_manual.indd 4-5
5/08/2016 2:40 pm
