• This product should never be used by any individual suffering from any
physical ailment that would limit the user’s capacity to operate the controls.
• This unit should not be used by children or invalids without adult
supervision.
Instructions for Use
To reduce the risk of electrocution, this appliance is equipped with a polarized plug
(one blade is wider than the other). This plug will fit in a polarized outlet only one
way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician to install the proper outlet. Do not change the plug in
any way.
• Plug into 120-volt outlet.
• To activate Massage, slide the gray switch up towards the massage head. The first
position (I) is Low intensity and the second position (II) is High intensity.
• To activate Massage with Heat, first activate Massage as noted above and then
press the red Heat button.
NOTE:
• The Heat function can only be activated when the massage
function is in use.
• Apply the massager lightly to the area you wish to massage. Massage the area for
a short period of time and move to another area. Never massage the same spot for
longer than 3 minutes.
CAUTION
- as stated in the “IMPORTANT SAFEGUARDS”
section of this manual, never use this appliance near the eyes or other sensitive
areas.
• Operation of longer than 20 minutes is not recommended and may cause over-
heating to the massager.
N
N oo tt ee :: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equip-
ment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur in a particular instal-
lation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help
Note: The manufacturer is not responsible for any radio or TV interference caused by unau-
thorized modifications to this equipment. Such modifications could void the user authority
to operate the equipment.
6
7
HG-20_A.qxd 7/24/08 3:06 PM Page 7
