Setting the Clock Time
1. Press the TIME SET BUTTON located on the top of the unit. (Figure 1) The hour
digit will flash. Push the DOWN or UP BUTTON until the correct hour is dis-
played. Remember to set the correct AM or PM (a PM icon is located on the left
hand side of display. There is no AM indicator). (Figure 2).
2. Press the TIME SET BUTTON again. The minute digit will flash. Push the DOWN
or UP BUTTON until the correct minute is displayed.
3. Press the TIME SET BUTTON again to exit the clock setting mode or after 8 sec-
onds the display will stop flashing to indicate the time is set.
Charging Your iPod/iPhone™
1. Place the universal dock insert that corresponds with your specific iPod/iPhone
in the docking area of the Dock n Party Ultra so the iPod 30-pin connector
passes through the opening in the insert. (Figure 3). You may contact HoMedics
Consumer Relations at 1-800-466-3342 to order the correct insert for your
iPod/iPhone.
Note: Make sure you use the universal dock insert that corresponds with
your specific iPod/iPhone and that it is properly docked into the Dock n
Party Ultra. Failure to do so may damage your iPod/iPhone.
WARNING:
THE iPOD DOCK IS DESIGNED FOR APPLE iPOD MUSIC
PLAYERS ONLY. ATTEMPTING TO ATTACH OR FORCE ANY NON- iPOD MUSIC
PLAYER INTO THE iPOD DOCK WILL
DAMAGE AND EVEN DESTROY
YOUR DEVICE.
2. Carefully place your iPod/iPhone into the docking area so the 30-pin connector in
the dock is fully connected to the 30-pin socket on the bottom of your
iPod/iPhone. (The iPod/iPhone must not be in a case or “skin”). You will hear a
“chirp” indicating that your iPod is properly connected.
6
7
Before You Begin
The Dock n Party Ultra uses a backup battery system to provide continuous
alarm and clock settings in the event of a power failure. Two “AA” batteries
(included) must be inserted into the battery compartment if memory
back-up is desired. When the Backup Battery is installed, in the event of a power
failure or the DC cord is accidentally disconnected, the LCD display will not be
illuminated, but the current time and alarm time settings will be temporarily
maintained.
Getting Started
1. Attach the DC adapter to the DC Jack located on the back of the unit.
2. Plug the cord into a 120V household outlet.
Install/Replace Batteries
Clock and alarm back-up batteries
1. Make sure the DC adapter is connected. Otherwise the time setting may be lost
during battery replacement.
2. Open the CLOCK/ALARM BACK-UP battery compartment located on the bottom
of the unit. (Figure 5)
3. Insert 2-AA batteries checking that the +/ – polarity follows the direction of the
instructions inside the battery compartment.
4. Do not mix different types of batteries together (e.g. alkaline with carbon-zinc or
old batteries with new).
5. Close compartment cover.
Portable battery operation
1. Open the two PORTABLE BATTERY POWER battery compartments located on
the bottom of the unit. (Figure 5)
2. Install 4-”C” cell batteries in each of the two PORTABLE BATTERY POWER bat-
tery compartments. Follow the instructions inside the battery compartment for
proper battery polarity.
3. Close compartment cover.
4. Remove the batteries if the product will not be used for a long time.
