16
15
Press the button
blinking hour
increasing hour
confirm the entry
repeat process to set time and date
DATE & TIME SET PROCEDURE
1. To adjust the date/time, press the
Set button
located on the side of the monitor. The display will
show a blinking number showing the hour.
2. Change the hour by pressing the
button
.
Each press will increase the number by one in a
cycling manner. Press the
Set button
again to
confirm the entry, and the screen will show a
blinking number representing the minutes.
3. Change the time and date as described in Step 2
above, using the
button
to change the num-
bers and the
Set button
to confirm the entries.
4. A “0” will reappear as the blood pressure monitor
is ready for measurement again.
APPLYING THE CUFF
1. Remove all watches, wrist jewelry, etc. prior
to attaching the wrist monitor. Clothing
sleeves should be rolled up and the cuff
should be wrapped around bare skin for
correct measurements.
2. Apply cuff to left wrist with
palm facing up as shown
in Fig. A.
3. Make sure the edge
of the cuff is about
1/4”~1/2” (1 cm) from the
palm as shown in Fig. B.
4. In order to insure accurate
measurements, fasten the
hook and loop strap
securely around your wrist
so there is no extra space
between the cuff and the
wrist as shown in Fig. C.
If the cuff is not wrapped
tight enough, the meas-
urement values will not be
accurate.
5. If your physician has
diagnosed you with poor
circulation in your left
arm, place the cuff around
your right wrist as shown
in Fig. D.
Fig. A
Fig. B
Fig. D
Fig. C
