AREA
Cheeks
Around Lips & Chin
Around Eyes
Forehead
Nose
MAX LEVEL
3
2
1
4
4
ROUTINE
(Level 3)
(Level 2)
(Level 1)
(Level 4)
(Level 4)
Charging the battery
When the level indictor LED flashes red, the product needs
charging. Connect the charging base to the mains using the USB
power lead and the appropriate plug. Place the handle in the
charging base and press down firmly. The LED lights will flash to
indicate that charging is taking place. When charging is complete
all the lights will stay on. It takes 4 hours for a full charge, which
will provide 90-120 minutes use, dependent on power levels
used.
Filter Fitting and Replacement
For correct operation it is very important that a new black wool
filter is fitted before each use of the device. The filter collects
dead skin cells and should be disposed of after use and then
replaced. Using the device without a filter will allow debris and
dead skin cells to enter the motor, shortening the life of the
product and invalidating the guarantee.
What to Expect
Regular microdermabrasion treatments can both restore and
maintain a youthful appearance to the skin. We advise starting
slowly with just one or two treatments a week, then building up
to treatments every other day if desired.
During use you should feel a gentle suction effect as the tip
moves across the skin and some people may also notice the slight
coarseness of the diamond tip.
Depending on your skin type, you may experience some
reddening or increased sensitivity after treatment. This is
perfectly normal and usually subsides within a few hours. You
may wish to consider this and make your first treatment at the
end of the day rather than just before going out.
Adverse reactions are rare, but if skin becomes unduly inflamed
or irritated, stop using the device immediately.
Facial Treatment Routine
• Wash and dry your face
• Remove the handle from the charging base and fit your choice
of diamond tip with a new black wool filter.
• Press and hold the power button for 2 seconds to turn the
unit on. Press again as required to increase the power level,
as indicated by the LEDs. It is recommended to start on level
1 for the first treatment and to progress to a higher level if
comfortable. See also MAX recommended levels in the above
diagrams
• Place the diamond tip flat against the skin until you feel suction
then move it slowly across the surface of the skin in a smooth
motion, covering the same area no more than 2-3 times in one
treatment. Do not press hard. In some areas it can help to hold
the skin taught with the other hand (eg. around the eyes).
• The diagrams above will help you establish an effective facial
routine.
After treatment cooling surface
• Press and hold the cooling button for 1 second. A blue LED
will glow indicating the cooling surface is activated
• Apply the cooling surface to the treated area to soothe the skin
post-treatment.
INSTRUCTIONS FOR USE
NOTE:
Avoid the sensitive
areas immediately above
and below the eye.
GB
I
2
GB
I
3
