7. APPLIANCE OPERATION
Connect to power & turn the knob “ON”. The product will make beep
sound indicating that it is on. Red light indicates lack of water. Turn off &
fill water. Adjust the frequency of mist by adjusting the knob. Do not
move appliance in working state. Appliance should be moved as a whole.
8. CLEANING AND MAINTENANCE
•Always unplug the unit before removing the water tank.
• Do not touch the water in the base during operation!
• Caution-risk of electric shock and damage to the product!
• Switch off the appliance and unplug it from the socket before cleaning it.
Clean the water tank and the base regularly. Use water only, no detergents.
8. TROUBLESHOOTING
In case of emergency, please, use the troubleshooting methods shown in
tables. If it is impossible to solve problem with these methods, contact our
customer care.
Problem
Possible cause
Remedy
Poor atomizing
(insufficient capacity)
The unit is operating in the
minimized mode (low atomizing
frequency)
There is no problem. If you need to
switch to the intense mode of
operation, turn the regulator handle
all the way to the right.
The atomizer is clogged
Clean the atomizer.
Temperature of water in the tank is
too low
Set maximum capacity. The
diffuser’s capacity will go up after
a while.
No atomizing
The power cord is poorly connected
to the outlet
Connect the power cord into the
outlet carefully
There is white deposit
on objects around the
diffuser (salts,
separating out from
water)
1. Lime deposits have formed on the
membrane
2. There are lot of salts in the water
used (calcium and magnesium)
1. Clean the diffuser’s membrane
with a special brush
2. Use filtered water
Steam has an
unpleasant odor
Stale water is used
Clean the unit according to the
cleaning and servicing instructions
and fill the tank with fresh & pure
water
Remains of stale water or waste
have accumulated in the unit’s case
or the atomizer
Condensate is formed
on the upper part of
the diffuser and on
surrounding objects,
when it is operating.
1. High humidification intensity is
set.
2. High room humidity and
temperature.
Lower the humidification intensity
by turning the on/off and steam
outflow intensity regulator
counterclockwise.
Water appears next to
the diffuser, when it is
operating.
1. High humidification intensity is
set.
2. Lime deposits have formed on the
membrane and in grooves for
water (in the unit’s base).
1. Lower the humidification
intensity by turning the on/off
and steam outflow intensity
regulator counterclockwise.
2. Clean the unit according to the
cleaning and servicing
instructions.
Water
appears/accumulates
next to the diffuser
Water tank is leaking
You need to contact an authorized
service center
Table 2