ADDING DEVICES
Pairing heaters with H+P programmer
Prepare the programmer
1
Prepare a heater
2
Heater was paired with
the programmer.
The same way you can add
next devices and group them
into zones (Z2 etc.)
Choose an icon
to the room you set
Zones status
1 2
3
Z 2
In zone Z1 (sleeping room) works 1 heater. Individual mode.
Works OK, temperature 20
°
C.
No faults.
1
Z 1
In zone Z2 (child room) works 3 heaters. Day mode.
Heater 1 and 2 work OK.
Heater No 3 shows an error!
Possible faults.
No communication between H+P programmer and
a heater. Check a range. Check does the heater is on.
Heater fault. Check the fault No at the heater’s controller.
Compare with the heater manual available at:
www.homeplus-system.com
select/DELETE
1x
1x
On heater controller:
Push BOTH butons
ONCE
Keep pressed an
upper button for
min. 3 seconds
to start pairing
3
sek
30 sec.
countdown
(9-1)
At this time pre-
pare the device in
H+P programmer
push icon +
The heater was
paired properly.
Before pairing please check if there’s a H+R remote
controller or H+S temperature sensor already paired.
The proper pairing is indicated on a heater display
10
