Please call for replacement parts or assistance:
1-866-942-5362
Whalen Storage
Factory No.: 15548
Page #10 of 11
Assembly Instructions
NOTE: If you buy more than one unit, the stacking configuration can be available.
14.
This cabinet featured stacking configuration. Repeat the same procedure to assemble the other shoe shelf unit.
Place one unit on the top of the other base unit making sure it is centered properly and back edges are even.
Using the Metal Bracket (J) as a template, mark the mounting hole locations at the back side of the Base Top
Panel and Hutch Side Panels, as shown in the illustration. With an electric drill and 1/16” drill bit (not
included), carefully drill into the marked location about 1/2” deep. Make sure that you will not crack the side
edges.
15.
To secure the units in place, attach the Metal Brackets (J) over the drilled holes using four M4x16 mm Pan
Head Screw (K) per Metal Bracket. Tightly fasten all the screws with a Phillips screwdriver.
TIPPING RESTRAINT HARDWARE
We have included one Tipping Restraint Hardware bag for this unit. You must install this hardware to
prevent accidents or injuries from falling unit.
When properly installed, this restraint can provide protection against the unexpected tipping of the storage
rack due to small tremors, bumps or climbing. We strongly recommended mounting this hardware to a
wall stud and your unit.
Please carefully read the instructions printed on the bag.
Note: You must install the Tipping Restraint Hardware with the unit in use to prevent any accidents or
damage to the unit.
Tools Required: Phillips Screwdriver, Mallet, Power Drill, and 3/8” Drill Bit.
