Operation
REMOTE CONTROL OPERATING INSTRUCTIONS
REMOTE CONTROL OPERATING INSTRUCTIONS
INSTALLING THE REMOTE CONTROL HOLDER
INSTALLING THE REMOTE CONTROL HOLDER
K
CC
DD
J
JJ
□
Remove the two remote control holder plugs (DD) from the
remote control holder (K). Note that the plugs have unique
tabs that allow them to fit only in one hole.
□
Attach the remote control holder (K) with the two remote
control holder mounting screws (CC).
□
Replace the two remote control holder plugs (DD) each into its
own hole.
□
Install the 12V MN21/A23 battery (JJ) (included) into the
remote control (J). To prevent damage to the remote control
(J), remove the battery if not used for long periods.
14
□
Restore power to the ceiling fan and test for proper operation.
HI, MED, LOW buttons: set the fan speed.
OFF button: turns the fan off.
button: turns the light on or off and also controls the brightness
setting. Press and release this button to turn the light on or off.
Press and hold the button to set the desired brightness. The light
button has an auto-resume, it will stay at the same brightness as
the last time it was turned off.
The dimming of the LED is only possible with the installation of the
receiver and the use of the remote. Wall slide controls used to
bypass the remotes will not be able to dim the light.