7
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Assembly - Standard Ceiling Mount
Routing the wires
Preparing for standard mounting
□
Route the wires exiting the top of the fan motor assembly
(E) through the decorative motor collar cover (D) and then
the center of the canopy bottom cover (FF).
□
Make sure the opening of the canopy (C) is on top and
insert the ball/downrod (B) through the canopy (C).
□
Route the wires exiting the top of the fan motor assembly
(E) through the downrod as shown.
2
1
□
Pull off the canopy bottom cover (FF) from the canopy (C).
□
Loosen the two canopy screws (EE) located in the bottom of the
mounting bracket (A), and turn the canopy counterclockwise to
remove the mounting bracket (A) from canopy (C).
Assembling the fan
□
Loosen, but do not remove, the setscrew (GG) on the collar (II) on
top of the fan-motor assembly (E).
□
Install the downrod (B) by inserting it into the motor collar (II),
and turning it clockwise until the holes at the bottom of the ball/
downrod assembly (B) align with the holes in the collar on top of
the fan-motor assembly (E).
□
Carefully insert the hanger pin (CC) through the holes in the collar
and ball/downrod assembly (B). Be careful not to jam the hanger
pin (CC) against the wiring inside the ball/downrod assembly (B).
□
Insert the locking pin (DD) through the hole near the end of the
hanger pin (CC) until it snaps into its locked position.
□
Re-tighten the setscrews (GG) on the collar on top of the fan motor
assembly (E).
3
CAUTION:
To ensure wobble-free operation and to avoid
damage to the fan, the downrod (B) and the setscrew
(GG) must be completely tightened.
NOTE:
The magnet is pre-attached on the canopy bottom
cover for you to remove and install easily.
C
A
EE
FF
C
D
FF
B
E
E
GG
DD
CC
B
WARNING:
Failure to properly install the locking pin
(DD) could result in the fan becoming loose and
possibly falling.
