3 HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Safety Information (continued)
CAUTION:
□
If possible,
ALWAYS
unplug this appliance when not in use.
□
DO NOT
operate any heater with a damaged cord or plug or after the heater malfunctions.
DO NOT
operate any heater if it has been dropped
or damaged in any manner. Disconnect power at service panel and have heater inspected by a reputable electrician before reusing.
□
Any repairs to this fireplace should be carried out by a qualified service person.
□
Under no circumstances should this fireplace be modified. Parts having to be removed for servicing must be replaced prior to operating this
fireplace again.
□
DO NOT
use outdoors.
□
This heater is not intended for use in bathrooms, laundry areas and similar indoor locations.
NEVER
place heater where it may fall into a
bathtub or other water container.
□
To disconnect this appliance, turn controls to the off position, then remove plug from outlet.
□
ONLY
connect to properly grounded outlets.
□
This appliance, when installed, must be electrically grounded in accordance with local codes, with the current CSA C22.1 Canadian Electrical
Code or follow U.S.A. Installations, follow local codes and the National Electrical Code, ANSI/NFPA N0.70.
□
To prevent a possible fire,
DO NOT
block air intakes or exhaust in any manner.
DO NOT
use on soft surfaces, like a bed, where opening may
become blocked.
□
The heaters
MUST NOT
be located immediately below a socket or outlet.
□
ALWAYS
plug heaters directly into a wall outlet / receptacle.
NEVER
use with an extension cord or re-loadable power tap (outlet / power
strip).
□
DO NOT
slide insert on top of wood to avoid scratching wood surface.
□
DO NOT
place any object on top of the insert or block the air intakes / vents as this can cause the unit to overheat and could cause a fire.
Electrical Connection
□
A 15-amp, 120-volt, 60 Hz circuit with a properly grounded outlet is required. Preferably, the fireplace will be on a dedicated circuit as
other appliances on the same circuit may cause the circuit breaker to trip or the fuse to blow when the heater is in operation. The unit
comes standard with 6-ft. three-wire cord, exiting from the rear of the fireplace.
DO NOT
exceed the current rating of the current tap.
Grounding Instructions
□
This heater is for use at 120 volts. The cord has a plug as shown below. See illustration or grounding instructions. An adapter as shown
at C is available for connecting three-blade grounding type plugs to two-slot receptacles. The green grounding plug extending from
the adapter must be connected to a permanent ground such as a properly grounded outlet box. The adapter should not be used if a
three-slot grounded receptacle is available.
SAVE THESE INSTRUCTIONS
A
B
C
Grounding Pin
Grounding Means
Metal
Screw
Cover of
Grounding
Box
Adapter
