Assembly
4
BB
2
Adhering the basin
3
□
Apply a layer of silicone on the underside of the top (B) along
the basin cutout, where the basin (C) will be in contact.
Lower the basin (C) onto the top (B), lining it up with the
cutout.
Wipe away any excess silicone.
□
□
CAUTION:
Do not over tighten the screws as this
could crack the basin.
Securing the basin
AA
□
Position the brackets (BB) so they clamp the basin (C) edge
to the top (B).
Thread the screws (AA) through the spaces in the brackets
(BB), then through the anchor in the top (B).
Tighten the screws with a screwdriver, turning it clockwise.
□
□
B
C
B
C
4
Sealing the basin
□
Apply a bead of silicone sealant where the basin (C) meets
the top (B).
Use a clean rag to push in the silicone and wipe away any
excess.
□
B
C
1
Attaching the feet
□
Carefully tip the vanity (A) backward to expose the drill
holes on the underside near the front.
Align the screw in the foot (E) with the hole. Turn the foot (E)
clockwise until the foot (E) is tight against the vanity (A).
Repeat with the other front foot (E), then with the center
support foot (G) and two back feet (F).
□
□
CAUTION:
Two people are needed to safely tilt the
vanity and access the underside.
A
E
G
F
