1
Preparing the canopy
2
Preparing the motor
□
Remove the canopy ring (B) from the canopy (C).
□
Remove the two non-slotted canopy mounting screw
with lock washer (BB) from the canopy (C), and loosen
the slotted canopy mounting screw with lock washer
(BB) on the canopy (C).
□
Remove the canopy (C) from the mounting bracket (A)
by turning the canopy (C) counterclockwise.
3
Assembling the fan
GG
FF
JJ JJ
A
BB
BB
C
B
B
F
E
C
JJ
JJ
FF
GG
II
HH
□
Remove the cotter pin (GG) and clevis pin (FF), and
loosen the two collar setscrews (JJ) from the motor
collar.
□
Take out the setscrew (II) located in the hanger ball
(QQ), lower the hanger ball and remove the cross pin
(HH). Remove the hanger ball (QQ) from the hanger
ball/downrod assembly (D).
□
Remove the ground lead (RR) from the downrod
assembly (D).
II
D
HH
□
Carefully feed the motor wires up through the
downrod (SS). Thread the downrod (SS) into the
collar.
□
Align the holes and replace the clevis pin (FF) and
cotter pin (GG). Tighten the two collar setscrews (JJ).
□
Slip coupling cover (E), canopy ring (B), and canopy
(C) onto the downrod (SS).
□
Carefully reinstall the hanger ball (QQ) onto the
downrod (SS) and reinstall the ground lead (RR) onto
the downrod (SS), being sure that the cross pin (HH)
is in the correct position, the setscrew (II) is tightened
and wires are not twisted.
WARNING:
Failure to properly install the cotter pin (GG)
could result in the fan loosening and possibly falling.
NOTE:
If a longer downrod (not included) is needed, take out
the screw located in the hanger ball (QQ), lower the hanger
ball (QQ) and remove the cross pin (HH). Remove all three
pieces from the downrod and assemble them onto the new
longer downrod before proceeding to the downrod installa-
tion.
RR
RR
SS
8
Assembly
