5
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Installation
(as a portable luminaire)
1
Preparing the unit for installation
2
Installing the mounting hardware
3
Installing the
fixture
Carefully unpack and lay all parts on a clean, level surface.
Assemble the tubes (B) to the fixture assembly (A).
4
Installing the shade and light bulb
Place the shade (C) over the fixture assembly (A) and insert the
shade frame into the two ears of the fixture assembly (A).
Install two 60 Watt E12 Type B Bulbs or CFL or LED equivalent
(not included).
Determine the desired location of the fixture making sure you have
access to an electrical outlet and there are no electrical lines or
plumbing where you intend to attach the mounting hardware.
Mark the anchor (AA) locations on wall and drill each hole 7 mm
in diameter.
Insert the anchors (AA) and tap into the wall until secure.
Set two screws (BB) into the anchors (AA) using a screwdriver, leaving
enough exposed to set into the keyhole slots on the fixture assembly.
B
B
B
B
A
C
A
Align the keyhole slots on the fixture assembly (A) with the
screws (BB) on the wall and then gently push the canopy toward
the wall and slide down until secure.
Attach the plastic clip (CC) to the appropriate location on the
bottom tube (B) and mark the outside edge of the plastic
clip (CC). Unthread the bottom tube (B) and move it away, drill a
hole 7 mm in diameter at the center of this marked location and
install the anchor (AA). Remove the pre-attached
plastic clip (CC)
from the bottom tube (B) and secure it to the anchor (AA) with
the flathead screw (DD).
Slide the bottom tube (B) through the plastic clip (CC) and thread
it to the assembled tubes (B).
A
BB
B
DD
CC
AA
CC
B
BB
AA
2.75 in./6.98cm
