Home Decorators Collection 1000640382, Инструкция по использованию и уходу

Страница: 7 / 36

www.homedepot.com/homedecorators
Please contact 1-800-986-3460 for further assistance.
3
Mounting the fixture

Place the back plate of the fixture body (A)
onto the fixture mounting screws (EE) and
secure it into place by using the lock nuts
(AA) provided.

Caulk the upper 2/3 rds of the back plate on
the fixture body (A).

Leave the bottom 1/3 rd un-caulked for
drainage of any water that may leak into
the enclosure.
Installation (continued)
7
Operation
GETTING STARTED
 Slide the “TIMER” switch to “TEST”.

Turn on power at the circuit breaker or fuse box.

Turn the light switch on to activate the fixture.
The light will turn on and remain on for approximately 45 seconds and then flash 3 times before
turning off. In TEST mode, the motion sensor will turn on the light when it senses movement. Four to
five seconds after movement has stopped, the light will turn off.
SETTING THE SENSITIVITY IN TEST MODE
 In TEST mode, slide the “SENSITIVITY” switch to a desired level: “L” for low, “M” for medium, or
“H” for high.

Test the sensitivity by walking towards the fixture from various angles, especially high traffic
paths such as driveways and walkways.
 If necessary, select a different “SENSITIVITY” switch position to increase or decrease the
sensitivity or range.

Continue to adjust the sensitivity until optimum results are attained.
A
AA
EE