Installation and Operation Manual
-‐ 8 -‐
INSTALLATION – Ducted or Re-circulating
The integrated rangehood can be installed in either ducted or re-circulating method. The
integrated rangehood is supplied with a small length of flexible duct, although may not be
sufficient in all installations. The installer needs to determine the method in which the
rangehood will be installed and may need to supply the appropriate components to duct
the rangehood correctly.
Ducted installation
Ducting components will need to be supplied by the installer as every installation can be
different. The size of the duct pipe needs to be no less than 150mm in diameter. Use of
smaller diameter duct pipe will effect performance and create air noise from the
rangehood.
The shelf above the top of the rangehood needs to removable, should the need for servicing
be required at a later date. The shelf needs to be located no less than 400mm above the
top of the rangehood as the metal motor housing supplied needs to be put in place after
the rangehood has been installed. Above the shelf a U-shaped box can be made to cover
the duct so it cannot be seen when the overhead cupboard is open. (Fig.5)
Motor housing cover
Duct spigot
150mm Ducting required
and ducted to outside of
the home
U-shaped box
to cover
ducting
(Needs to be
removable)
Removable shelf
(Cannot be permanently
fixed if the need for
servicing is required)
Shelf support
brackets x 4
Fig. 5
Motor housing cover
Duct spigot
150mm Ducting required
and ducted to outside of
the home
U-shaped box
to cover
ducting
(Needs to be
removable)
Removable shelf
(Cannot be permanently
fixed if the need for
servicing is required)
Shelf support
brackets x 4
Fig. 5
