Assembly
Assembling the Tinsel Witches
Step 1. There are 3 Witches Bodies. Lay the Bodies out on the floor to match up the correct Body
Halves before you proceed. Insert the rods of the Upper Body of Witch (B) into the matching holes
on the Lower Body of Witch (C) for the three different Witch Bodies then fasten together with the
Plastic Ties (I). Stack and lock the narrow end of the Support Pole (G) into the " T " shaped Base (G).
Stand the assembled Witches then insert the top bent end of the Supporting Pole and Base into the
matching hole on the back of Body of Witches. Fasten with the Cotter Pin (L). (FIG.1)
Step 2. Stand the Cauldron up and attached the short Support Pole and Base to the back side of
Cauldron. Use the Cotter Pin to secure the Support Pole to the Cauldron. (FIG.3)
Step 3. Place the Hats (A) into matches holes on the head of each Witch (FIG.2) and insert the
Arms/Hands (D) into the matching holes on each Witch's body (following the diagram for the correct
Witch Body) then fasten them together with the Plastic Ties (I). (FIG.3)
Step 4. Insert the Stirring Stick (F) into the matching holes on the Hand of the hunched over Witch and
the top inside of Cauldron then fasten them together with the Nylon Ties (I). (FIG.3)
Step 5. Insert Ground Stakes (H) into the ground securing the base of each Witch and the
Cauldron. (FIG.3)
Pre-Operation
CAUTION:
Grasp the plug to insert or remove from the power source.
Do not unplug by pulling on cord.
CAUTION:
The lighting string on this product is rated at 28.8 Watts
(0.24Amps) and 40.8 Watts (0.34Amps). Do not overload. Do not connect to another
lighting string, decorative outfit or other product. Before you use or re-use this product
inspect it carefully. Return the product to place of purchase with receipt if the product
has cuts, damage, frayed wire insulation on cords, cracks in the socket enclosures,
loose connections or exposed copper wire.
Care and Cleaning
a. Carefully remove the product from wherever it is placed. This helps to avoid any
undue strain or stress on the product conductors, connections, and wires. If the
product is placed somewhere other than the ground it should be well secured and
stable.
b. Wipe the product with a damp cloth and allow the product to dry before storing.
c. Store the product neatly in a cool, dry location protected from sunlight.
FOR INDOOR AND OUTDOOR USE
FIG.1
FIG.2
FIG.3
