3/3
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: Reorient or relocate the receiving antenna,
Increase the separation between the equipment and receiver, Connect the equipment into an outlet on a
circuit different from that to which the receiver is connected. Consult the dealer or experienced radio/TV
technician for help.
CAN ICES-3(B)/NMB-3(B)
OPERATION INSTRUCTIONS:
1. Plug the power adapter into a standard power outlet and adjust the settings on the Function Control
Box, located on the Torso Frame, as desired.
2. Settings:
Sensor: This switch mode will activate lights, sound, and animation when the Infra-red (IR) sensor is
activated and will operate for 1 audio-cycle with each activation. The Infra-red (IR) sensor has a range of
up to 2 m/6.5 ft. and will activate when someone comes within an 80-degree angle from left-to-right, as
well as from above and below.
/OFF/Try Me: This switch mode allows the item to be activated only if triggered by using a Step Here Try
Me Activation Pad (Not Included). The item will operate for one audio cycle with each Try Me activation.
I / ON : This switch mode will continuously operate the lights, sound, and animation of the item.
: Raise or lower the volume using the volume control turn dial, turn all the way down to turn the
volume off .
Sensor / D
étec
teur
5.9 V
Try Me / Essaie
-moi / P
ruébame
Sensor / D
étec
teur
5.9 V
Try Me / Essaie
-moi / P
ruébame
Distributed by Home Depot
2455 Paces Ferry Road Atlanta, GA 30339
1-877-527-0313
7
.
1
Your Gravedigger is now fully assembled. Plug
in and turn on to let the fun begin!
Cable pairs are
color-coded to insure
proper color-match-
ing connections.
Be sure nothing is
blocking the sensor.
IR SENSOR
