ASSEMBLY
1 Remove the Try-Me Button
Remove the packing and take out the product carefully. Place all parts
flat on the ground or table. Disconnect the plug on the Try-Me Button
(C) from the controller.
2 Assembling the Clown Head and Controller to the Stake
Insert the non-pointed end of the Stake (D) into the connecting hole at the
bottom of each Clown Head (A) and the Controller (B) until firmly tight.
Note: Handle the handle Clown Head (A) with care while performing this
task. Hold the Clown Head steady then push and twist the Stake into
position.
3 Anchoring the Ground Stakes
Insert the Ground Stakes (D) into the ground by grasping the Ground
Stake in the middle then firmly pushing into the ground. Note: Do not
push down on the top of the Clown Head. This could cause breakage.
Hint: If the ground is hard use water to moisten the ground for an easier
install.
4 Accessing Battery compartment on Controller
Unlock the hinged clips at one side of the Controller (B). Open the cover.
Note: Do not remove the silicon gasket.
5 Installing and Replacing the Batteries
Fitting the batteries; Requires 3 "AA" Batteries (sold separately), one
after another, into the Battery Compartment of the Controller. Make
sure the Batteries are placed in the correct direction with the polarity
matching what is indicated on the inside of the Battery box.
6 Securing the Battery compartment cover on Controller
Close the cover. Lock down the hinged clips firmly.
7 Operating
the
Controller
On the back side of the Speaker is a power switch. Move the switch to
ON. This will activate the built in sound sensor. When the sound sensor
is activated the speaker will play phrases and the mouths will move.
C
D
B
A
D
B
